Buying Guides · May 29, 2026 · 6 min read
Elphapex DG2, DG2+ and DG2 Mini Compared
The DG2 generation split into three machines aimed at different sites: full-size units for warehouses, and the Mini for people who need Scrypt hashrate without a dedicated building.
This guide is written from how we source, bench-test, deploy and service Elphapex DG2 hardware at our Hong Kong facility. Every recommendation links to machines we actually hold in stock, so you can go from research to a shortlist and a delivered price in one step — with shipping to the USA, Canada and Europe.
Buying Checklist for a Elphapex DG2
Ask five questions before money moves: what the measured hashrate and wall draw were on the test bench, which firmware version is installed, whether hashboards are original or replacements, what the warranty covers in writing, and who pays return shipping if the unit arrives dead. A supplier that answers all five in writing is a supplier worth buying from.
Refuse pressure tactics, avoid escrow-free peer-to-peer deals for machines you cannot inspect, and confirm delivered pricing including freight and duty. Our Elphapex DG2 stock is bench-tested and hashrate-verified from our Hong Kong facility, with worldwide shipping to the USA, Canada and Europe and written warranty terms.
Elphapex DG2 Specifications That Actually Matter
The Elphapex DG2 ships rated up to 19 GH/s, 3,800 W at the wall, roughly 0.2 J/MH efficiency, Scrypt algorithm, air cooling. Those four numbers — hashrate, wall draw, efficiency and cooling method — decide everything else: what circuit you need, how much heat the room absorbs, and how the machine behaves when network difficulty climbs. Everything a spec sheet lists beyond that is packaging.
Treat the rated figures as a ceiling rather than a promise. Air-cooled units typically settle two to five percent below datasheet output once intake air passes 30 degrees Celsius, while liquid-cooled siblings hold their numbers far more consistently. We bench every Elphapex DG2 before it ships and record the actual hashrate and wall draw on the test sheet that travels with the unit.
Running Cost: What Elphapex DG2 Electricity Looks Like
At 3,800 W continuous the Elphapex DG2 consumes roughly 91 kWh per day. At six cents per kilowatt hour that is about $5 of power per day; at twelve cents it doubles to roughly $11. Multiply by 30 and you have the only fixed cost that never negotiates.
Because power is the dominant cost, your electricity rate — not the purchase price — decides whether this machine belongs in your fleet. Run the numbers with hashprice cut by 30 percent before you buy. If the Elphapex DG2 still clears its own power bill in that stressed scenario, the purchase survives a bad quarter; if it does not, you are betting on price appreciation rather than on mining.
Heat, Noise and Where the Machine Can Live
An air-cooled Elphapex DG2 produces 72 to 80 dB continuously and dumps its entire 3.8 kW into the room as heat. That rules out living spaces without a garage, outbuilding, ducted enclosure or hosting contract. Noise, not electricity, is the reason most home mining purchases get resold within a month.
Whatever the cooling method, intake temperature is the metric to instrument. Log intake, exhaust and chip temperatures, alarm on 75 degrees Celsius chip temperature, and clean filters on a fixed schedule. Thermal discipline is the difference between a five-year machine and an eighteen-month one.
Used and Refurbished Elphapex DG2 Units: What Changes
Second-hand Elphapex DG2 hardware is where the best dollars-per-terahash usually live, but the risk profile shifts to you. Insist on a load test at full power for at least an hour, verify all hashboards report the expected chip count, check for corrosion on the board edges and PSU connectors, and look for replaced fans or reflowed chips — signs the unit has been repaired before.
Price used units at a level you would be comfortable writing off inside twelve to eighteen months. Every refurbished machine we sell is stripped, cleaned, load-tested and re-benched, and we publish the measured numbers rather than the datasheet numbers so you can price the risk honestly.
Hosting vs Running It Yourself
Hosting makes sense when your own power is expensive, your site cannot absorb the noise and heat, or you want more machines than your electrical service supports. A hosted Elphapex DG2 typically bills a flat rate per kilowatt hour plus a management fee, and the operator handles cooling, networking, reboots and basic repairs.
Run the comparison honestly: hosting rate versus your delivered residential or commercial rate, plus the value of your own time and the capital you would spend on electrical work. If hosting costs less than three cents per kWh above your own rate, the operational relief is usually worth it — especially for older hardware where uptime discipline decides profitability.
Frequently Asked Questions
- What is the Elphapex DG2 hashrate and power draw?
- The Elphapex DG2 is rated at up to 19 GH/s drawing 3,800 W at the wall, which is roughly 0.2 J/MH. Expect two to five percent below rated output in warm ambient conditions.
- How much electricity does a Elphapex DG2 use per day?
- Roughly 91 kWh per day of continuous operation — about $7 per day at eight cents per kilowatt hour, or $219 per month.
- Is the Elphapex DG2 still profitable?
- That depends on your power rate more than anything else. Model it with hashprice cut 30 percent: if the machine still covers its own electricity, it is a defensible buy.
- Can I run a Elphapex DG2 at home?
- Only with a dedicated 240 V circuit, real ventilation and tolerance for 72-80 dB. Most buyers end up ducting the exhaust, using an outbuilding, or hosting the machine.
- Do you sell used Elphapex DG2 units with a warranty?
- Yes. Every used and refurbished unit is stripped, cleaned, load-tested and hashrate-verified before shipping, and ships with written warranty terms and worldwide delivery from Hong Kong.
Recommended Miners From Our Inventory
Hardware in stock that matches this guide. Every unit is bench-tested and hashrate-verified before it ships.

Bitmain Antminer U2L9H 27 Gh/s LTC Miner
27 Gh/s | 5670W
Scrypt · New
$5,670

Bitmain Antminer L9 16 Gh/s LTC Miner
16 Gh/s | 3360W
Scrypt · New
$3,360

Used Bitmain Antminer L9 17 Gh/s Dogecoin & Litecoin Miner
17 Gh/s | 3570W
Scrypt (DOGE & LTC) · Used
$9,890$10,450

Used Bitmain Antminer L9 17 Gh/s Hydro Conversion with 12kW Radiator Kit
17 Gh/s | 3570W
Scrypt (DOGE & LTC) · Used
$11,290$11,900

Used Bitmain Antminer L9 16 Gh/s Scrypt Dogecoin Miner
16 Gh/s | 3360W
Scrypt (DOGE & LTC) · Used
$8,990$9,450

Bitmain Antminer L9 16.5 GH/s Litecoin & Dogecoin Miner
16.5 GH/s | 3360 W
Scrypt · Used
$8,900
Want the numbers run for your site?
Send us your electricity rate, available amperage and budget. We will model the machines that actually pay back at your power cost — no obligation.
Talk to an engineer